JLG EcoLift 50 Operation And Safety Manual page 15

Table of Contents

SECTION 1 - SAFETY PRECAUTIONS

• Do not elevate platform while on or near a sloping, uneven, or soft

surface. Ensure machine is positioned on a smooth, firm surface

within the limits of the maximum operating slope before elevating

platform.

• Before operating on floors, bridges, trucks, and other surfaces,

check allowable capacity of the surfaces.

• Never exceed the maximum platform capacity as specified on the

platform. Keep all loads within the confines of the platform, unless

authorized by JLG.

• Keep the chassis of the machine a minimum of 2 ft (0.6 m) from

holes, bumps, drop-offs, obstructions, debris, concealed holes,

and other potential hazards at the ground level.

• Do not operate the machine when wind conditions exceed specifi-

cations shown in Section 5 or as shown on the capacity placard on

the platform billboard. Factors affecting wind speed are; platform

elevation, surrounding structures, local weather events, and

approaching storms.

• Wind speed can be significantly greater at height than at ground

level.

1-6

• Wind speed can change rapidly. Always consider approaching

weather events, the time required to lower the platform, and

methods to monitor current and potential wind conditions.

• Do not cover or increase surface area of the platform or the load.

Do not carry large surface area items in the platform when operat-

ing outdoors. The addition of such items increases the exposed

wind area of the machine. Increased areas exposed to wind will

decrease stability.

• Never operate machine in high wind, rain, or snow.

• Do not perform work that will subject unit to a horizontal force or

create a swaying motion of the platform.

• Never attempt to use the machine as a crane. Do not tie-off

machine to any adjacent structure. Never attach wire, cable, or any

Table of Contents

Ecolift 70