Motor Layout; Unlocking The Cutter - Ricoh TR5050 Field Service Manual

Motor Layout

No.
1
2
3
4

Unlocking the Cutter

If an SC is generated due to cutter lock, release it using the following method.
1. Turn the power OFF and then ON
If the cutter was locked due to reasons such as a common jam, after restarting the machine the
cutter will rotate in reverse and recover automatically.
• When the cutter is locked, the cutting edge of the cutter may be chipped. After unlocking
the cutter, check if there is any problem with the cutting edge.
2. If the problem is not resolved even after turning the power OFF and then ON, use the cutter shifting
button at the lower left of the board to move the cutter to its home position.
Pressing the button once will trigger a recovery movement (cutter reverse rotation) for 0.1 sec only.
Holding down the button will not lengthen the cutter's reverse rotation. Therefore, press the button
several times slowly (at about 1 sec pitch).
Tray motor
Cut position motor
Exit motor
Feed motor
1.Detailed Descriptions
Part
7