Quick Installation - Tripp Lite SmartPro SLT 220/230/240V Pure Sine Wave Input/Output Owner's Manual

Quick Installation

With the UPS disconnected from
1
utility power, use a small tool to
set the Voltage Dip Switches to
match your input voltage. (All
models are preset to the 230V
setting.)
Insert a user-supplied power cord
2
(with country-specific plug) into
the UPS System's AC input
receptacle. Plug the cord into
an AC wall outlet.
NOTE! after you plug the UPS into a live AC outlet,
the UPS (in "Standby" mode) will automatically
charge its batteries,* but will not supply power to its
outlets until it is turned ON.
* The BATTERY CHARGE LED will be the only LED illuminated.
3 Find one of the power cords that
came with the UPS. Insert the
cord's female plug into
computer's AC input. Insert the
cord's male plug into any UPS
female output receptacle.
4 Plug your equipment into the UPS.
Plug your equipment into the UPS. Repeat Step 3
above using the additional power cord(s) that came
with the UPS.
Note: Additional interconnection cords (C13 to
C14) are available from Tripp Lite. Call 773-869-
1234 (Part # P004-006).
Your UPS is designed to support computer equipment only. You will
overload the UPS if the total VA ratings for all the equipment you
connect exceeds UPS output capacity. To find your equipment's VA
ratings, look on their nameplates. If the equipment is listed in amps,
multiply the number of amps by 240 to determine VA. (Example:
1 amp × 240 = 240 VA). If you are unsure if you have overloaded your
UPS's outlets, see "OUTPUT LOAD LEVEL" LED description.
5 Turn the UPS ON.
Press and hold the "ON/OFF/STANDBY" button for
one second. The alarm will beep once briefly after one
second has passed. Release the button.
SMX750SLT
230V
220V
240V
230V
1
2
3
4
5
3
SMX1050SLT &
SMX1500SLT
240V
230V
220V
230V