Jump Starting - Motomaster 011-2064-0 Instruction Manual

10
model no. 011-2064-0 | contact us: 1-888-942-6686
OPERATION

JUMP STARTING

Warning! Instructions are for negative ground systems only
(most common for vehicles today). If your vehicle is a positive
ground system, reverse steps 3 and 4. Please consult your
vehicle's manual to con rm your vehicle's ground system.
1. Firmly insert the booster clamps into boosting clamps connection port.
2. Press to turn the unit on.
3. Connect the red clamp to the POS (+) terminal of the vehicle battery.
4. Connect the black clamp to the NEG (-) terminal of the vehicle battery.
5. Check battery level indicator. If less than 3 bars, recharge the unit
before attempting a jump start.
6. Check display status and proceed as per instructions below.
1
4
12 Volt
Proceed as per A, B or C
6
2
3
5
11
The unit has detected a good connection with a battery.
OK
A
Proceed to Step 6.
Battery clamps are connected to the opposite terminals.
B
Reverse clamp connections before proceeding to Step 6.
（alarm）
The unit cannot detect a connection. Reconnect the
clamps and ensure proper contact with the battery
C
terminals. If connection indicator is still blank, see Low
Voltage Batteries/Manual Override section.
OK
The number '50' will icker
three times.
7. Try starting the vehicle. Most vehicles will immediately start. Some vehicles
may require the unit to be connected for up to 30 seconds before starting. If
the vehicle does not start right away, wait 20-30 seconds between attempts.
CAUTION: Do not attempt more than 5 consecutive jump starts within a 15
minute period. Allow the product to rest for 15 minutes before attempting to
jump start the vehicle again.
8. Once your vehicle starts, press
clamps.
OK
The icon appears and a
countdown begins. You have 50
seconds to jump start your vehicle.
to turn the unit off. Disconnect the battery