Led Light; Usb Power - Motomaster 011-2064-0 Instruction Manual

16
model no. 011-2064-0 | contact us: 1-888-942-6686
1. Roll-out the Air Compressor Nozzle Connector on the side of the unit.
2. a) For in ating tires or other objects with valve stems, screw in the nozzle
connector to the valve stem.
b) For in ating sporting equipment, party balloons or other objects without
valve stems, screw in the appropriate adaptor into the nozzle connector
and insert it into the object being in ated.
3. Press to turn the unit on.
4. Press and hold or for a few seconds until the compressor pressure
indicator starts to icker. Adjust to desired pressure (
pressure and to decrease pressure).
5. Release or once desired pressure is reached. The PSI reading will
ash a few times then go to 0 PSI. This means the pre-set pressure was
successfully recorded by the unit.
6. Press to operate the compressor. Unit will automatically shut-off once
desired pre-set pressure is reached.
7. Once unit has nished in ating, press
8. Unscrew the nozzle connector from the valve stem of the object being
in ated. If using an adaptor, disconnect from object being in ated and
remove adaptor from nozzle connector.
9. Store air hose and ball/balloon adaptors in the appropriate storage compart-
ments.
to increase
to turn the unit off.
17

LED LIGHT

IMPORTANT! Make sure LED light is OFF when unit is being recharged or stored.
1. Press to turn unit on.
2. Press to turn the LED light on.
3. Press again to turn the LED light off.
The light is adjustable 90°.

USB POWER

IMPORTANT! Make sure there are no devices plugged in to the USB power port
when unit is being recharged or stored.
The unit is equipped with 2 USB ports(2.4 A output in total).
charging portable electronic devices such as smartphones, tablets and more.
1. Lift protective cover labelled ''USB'' to expose USB ports.
2. Connect device(s) to USB port(s).
3. Press to turn unit on and activate USB power.
4.The display will show ''USB 5 V'' indicating the USB power is on.
This port is ideal for