Battery Status; Usb Power; Jump Starting - Motomaster 011-2062-4 Product Manual

8
model no.011-2062-4

Battery Status

Press the button. The Internal Battery Level Indicator LEDs will illuminate to
indicate battery capacity level.

USB Power

IMPORTANT!
Make sure there are no devices plugged in to the
USB power port when unit is being recharged or stored.
The unit is equipped with a USB port Quick Charge 5V,2.4A / 9V,2A / 12V,1.5A power output
This port is ideal for charging portable electronic devices such as smartphones,
tablets and more.
Connect device(s) to USB OUT port(s) using a USB cable .
1
Press to turn unit on and activate USB power .
2
contact us 1 888 942-6686

Jump Starting

WARNING! EQUIPMENT DAMAGE
Do not crank the engine for more than 3 seconds at a time. The jump start feature
is designed for short term operation only. Operating the jump start feature for
more than 3 seconds may cause damage to the unit.
If engine does not start, wait at least 30 seconds between attempts.
Do not attempt more than 5 consecutive jump starts within a 15 minutes period.
Allow the product to rest for 15 minutes before attempting to jump start the vehicle again.
Risk of shock, fire, combustion, and burns, do not dissemble, modify, crush,
heat above 60°C (140°F) or incinerate.
Do not attempt to jump start an engine if the battery level is at 50% or less.
Doing so lowers the chance of successfully boosting your vehicle.
Do not place the unit where it could fall when vehicle starts up.
Make sure that cables are routed away from motor fan or belts.
For 12V vehicles only
Warning!
Instructions are for negative ground systems only (most
common for vehicles today). If your vehicle is a positive
ground system, reverse steps 2 and 3. Please consult your
vehicle's manual to confirm your vehicle's ground system.
Connect the Smart Jumper Cables to the unit.
1
2 Connect the red clamp to the POS (+) terminal of the vehicle battery.
Connect the black clamp to the NEG (-) terminal of the vehicle battery.
3
Press to turn the unit on. If less than 75%, recharge the unit before
4
attempting a jump start.
Check LEDs on Smart Jumper Cables, and proceed accordingly:
5
9