Typical Access Point Installation Components - Cisco Aironet 1570 Series Mounting

Typical Access Point Installation Components

Typical Access Point Installation Components
The access point is designed to be installed in an outdoor environment, such as on exterior walls, off
cable strands, and on vertical and horizontal poles, such as streetlight poles. Carefully review
to become familiar with the system components, connectors, indicators, cables, system interconnection,
and grounding.
Note The illustrations in this document show all available connections for the access point. Unused
connections are capped with a connector plug to ensure the watertight integrity of the access point,
except for the AC power entry connector on the in AP1572EAC version access point. Liquid-tight
adapters are provided for connector openings, which can be installed before or after deploying the access
point.
When not using the AC input connector to power the in AP1572EAC version (for example when
powering using the Cisco power injector), it is important to cover the AC power entry connector. The
correct cap is Remke part number 75-0086 (http://www.remke.com/). This cap is included with the
AIR-PWRINJ1500-2= power injector. If you are using PoE directly from a switch or powering via DC,
then you will need to order AIR-ACC15-AC-CAP=.
Figure 3-1
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
3-4
Components in a Typical Access Point Installation
9
10
Chapter 3
1
2
8
4
7
5
6
Mounting the Access Point
Figure 3-1
OL-32138-01