Asus M2N68 Manual page 38

Table of Contents

Advertisement

3.
Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4)
These connectors are for the Serial ATA signal cables for Serial ATA 3.0
Gb/s hard disk and optical disk drives. The Serial ATA 3 Gb/s is backward
compatible with Serial ATA 1.5Gb/s specification.
The current Serial ATA I interface allows up to 150 MB/s data transfer rate
while Serial ATA II allows up to 300 MB/s data transfer rate, faster than the
standard parallel ATA with 133 MB/s (Ultra DMA133).
If you install Serial ATA hard disk drives, you can create a RAID 0, RAID 1,
RAID 0+1, RAID 5, and JBOD configuration through the onboard NVIDIA
MediaShield™ controller.
M2N68 SATA Connectors
Install the Windows
before using Serial ATA.
1-26
M2N68
2000 Service Pack 4 or the Windows
®
For detailed instructions on how to configure RAID 0, 1, 0+1, 5,and
JBOD, refer to the RAID manual in the support CD.
By default, RAID function of these connectors is set to [Disabled]. If
you intend to create a Serial ATA RAID set using these connectors, enable
the nVidia RAID Function item in the IDE Configuration sub-menu in
the BIOS. See section "2.3.4 IDE Configuration" for details.
SATA2
SATA1
SATA3
SATA4
Chapter 1: Product introduction
®
XP Service Pack1
®

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents