Table of Contents
Advertisement
2.
Open Network.
Network
3.
Make the proper network configurations.
Each network interface is enabled immediately when you check the box next
to it.
•
If you use a network cable connected to a home router (which is then connected
to your DSL/cable modem), enable both LAN1 and LAN2. Express Gate will
automatically use whichever port (LAN1 or LAN2) is connected.
If you plug the network cable into a different port while Express Gate is running
(e.g. move the cable from LAN1 to LAN2), you may need to press the "Refresh"
button to detect the change.
•
The most common scenario is for your computer to automatically obtain network
settings (i.e. DHCP). If this is the case, you don't need to click Setup for any
LAN port. If this is not the case, click Setup to configure the static IP settings
manually.
3-18
Chapter 3: Software support
Hide quick links:
Advertisement
Table of Contents
