Grounding - Chicago Electric 93457 Assembly And Operating Instructions Manual

This Welder requires the installation of a 3-Prong, 230 VAC, polarized,
The Plug must be installed by a certified electrician.
(See Figure A, and Electrical Schematic, page 27.)
Improperly connecting the grounding wire can result in the risk of electric
shock. Check with a qualified electrician if you are in doubt as to whether the
outlet is properly grounded. Do not modify the power cord plug used with
the tool. Never remove the grounding prong from the plug. Do not use the
tool if the power cord or plug is damaged. If damaged, have it repaired by
a service facility before use. If the plug will not fit the outlet, have a proper
GROUNDED TOOLS: TOOLS WITH THREE PRONG PLUGS
1. Tools marked with "Grounding Required" have a three wire cord and three prong
grounding plug. The plug must be connected to a properly grounded outlet. If the
tool should electrically malfunction or break down, grounding provides a low
resistance path to carry electricity away from the user, reducing the risk of electric
shock. (See Figure A.)
2. The grounding prong in the plug is connected through the green wire inside the
cord to the grounding system in the tool. The green wire in the cord must be the
only wire connected to the tool's grounding system and must never be attached
to an electrically "live" terminal. (See Figure A.)
Your tool must be plugged into an appropriate outlet, properly installed by a
3.
certified electrician and grounded in accordance with all codes and ordinances.
The plug and outlet should look like that in the following illustration.
(See Figure A.)
FIGURE A
SKU 93457 For technical questions, please call 1-800-444-3353.

GROUNDING

NOTE:
twistlock Power Cord Plug (not included).
WARNING!
outlet installed by a qualified electrician.
230 VOLT, GROUNDED,
3-PRONG,
POWER CORD PLUG
230 VOLT, GROUNDED,
ELECTRICAL OUTLET
Page 10