Grounding; Extension Cords; Symbology; Unpacking - Chicago Electric 93793 Set Up And Operating Instructions Manual

produces chemicals known to the State
of California to cause cancer and birth
defects (or other reproductive harm).
(California Health & Safety Code §
25249.5, et seq.)
SaVe theSe InStructIOnS

Grounding

this Welder requires the installation of a
3-prong, 240 V~, polarized,
twistlock power cord plug (not included).
NEMA configuration # L6-30 or equivalent
The Plug must be installed by a certified
electrician.
WarnInG!
Improperly connecting the grounding
wire can result in the risk of electric shock.
Check with a qualified electrician if you are
in doubt as to whether the outlet is properly
grounded. Do not modify the power cord
plug used with the tool. never remove the
grounding prong from the plug. Do not use
the tool if the power cord or plug is damaged.
If damaged, have it repaired by a service
facility before use. If the plug will not fit the
outlet, have a proper outlet installed by a
qualified electrician.
GrOunDeD tOOlS: tOOlS WIth
three prOnG pluGS
1. Tools marked with "Grounding Required"
have a three wire cord and three prong
grounding plug. The plug must be
connected to a properly grounded outlet.
If the tool should electrically malfunction
or break down, grounding provides a
low resistance path to carry electricity
away from the user, reducing the risk of
electric shock.
SKU 93793
nOte:
For technical questions, please call 1-800-444-3353.
2. The grounding prong in the plug is
connected through the green wire inside
the cord to the grounding system in the
tool. The green wire in the cord must
be the only wire connected to the tool's
grounding system and must never be
attached to an electrically "live" terminal.
3. Your tool must be plugged into an
appropriate outlet, properly installed by
a certified electrician and grounded
in accordance with all codes and
ordinances.

extension cords

an extenSIOn cOrD MuSt neVer
Be uSeD WIth thIS IteM. use of
an extension cord could result in
damage to the item or fire.

Symbology

Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
V~
Volts Alternating Current
a
Amperes
No Load Revolutions per Minute
n 0 xxxx/min.
(RPM)

unpacKInG

When unpacking both boxes, make
sure all the parts shown on the parts lists
on pages 29 through 31 are included. If
any parts are missing or broken, please call
Harbor Freight Tools at 1-800-444-3353 as
soon as possible.
Page 9