eQ-3 MAX! Operating Manual page 32

• Remove the protective film from the adhesive strip.
• Press the assembled Wall Thermostat with the back
side to the wall in the position where it should sub-
sequently be attached.
Screw mounting:
• Choose a site for installation.
• Make sure that electrical lines in the wall will not
be damaged.
• Position the mounting plate on the desired site on
the wall. Make sure that the arrow on the mounting
plate is pointing upwards.
• Use a pen to mark the positions of 2 bore holes A
(diagonally opposite) in the mounting plate on the
wall. The bore holes B can be used for installation
with a flush-mounting box.
A
• If you are working with a stone wall, drill the marked
two 5 mm holes and insert the plugs supplied. If
32
<PA66>
B
B
B
A
B