Display - Toyota 8FBE18T Operator's Manual

2 3 4
5
1
6
7
5 7
4
1
3
2
6

DISPLAY

The multi-function display helps operators to identify
various information easily by changing screens
depending on the vehicle conditions
Multi-function display deluxe (OPT)
The Multi-function display Deluxe model has the fol-
lowing functions added to the multi-function display.
• Mast tilt indicator
• Load meter
• Over load alarm
Initial screen
Initial screen is displayed for two seconds after key-
switch is turned on.
1) Date display
2) Travel speed limiter active
3) Overspeed alarm active
4) Auto speed control active
5) Maximum height limiter active
6) Shock sensor present
7) Active mast front tilt control disabled
Some features are explained further in this chapter.
Work screen
Different features are displayed on screen, depending
if the truck is traveling or stopped.
1) Battery capacity indicator
2) Power select indicator
3) Time indicator
4) Direction indicator
5) Wheel indicator
6) Speedometer
7) Mast tilt indicator
Some features are explained further in this chapter.
Battery capacity indicator
Battery capacity indicator indicates amount of charge
in the battery in 10 stages.
When the battery capacity reaches the set warning
level of remaining charge (default: second level):
(1) The battery capacity blinks.
(2) After the key switch is turned to ON, a warning
buzzer sounds for 5 seconds.
If the battery is further discharged, all segments in the
battery level indicator blink and a buzzer sound to
warn the operator.
Caution Caution Caution
• If the battery capacity indicator blinks, stop
operation early and charge the battery.
• To change the set level, consult with a Toyota
dealer.
Power select indicator
Three modes of traveling/material handling perform-
ance are displayed.
H ........ H mode
The most active mode.
P......... P mode
The high efficiency mode.
S......... S mode
The longest operation mode.
Note:
H mode is the setting that focused on working effi-
ciency, and maximum performance is demonstrated
with traveling and material handling. Operating hour is
about 65% of S mode. P mode is the setting that
focused on the balance between working efficiency
and operating hour. Operating hour is about 80% of S
mode. S mode is the setting that focused on operating
hour. Operating hour is same as S mode of previous
model
Time indicator
It shows time: hour and minute (in 12/24 hours).
Speedometer
Speedometer indicates the vehicle speed digitally in 1
km/h or 1 mph. When the truck is stopped, this part of
the display changes in the wheel indicator mode.
9
En
(En-8)