Switches And Levers - Toyota 8FBE18T Operator's Manual

SWITCHES AND LEVERS

Key switch
Insert the key with the teeth facing upward.
OFF ........ The key can be inserted and pulled out
in this position.
I
ON.......... Turn the key in a clockwise direction
from the OFF position. The vehicle is
ready to start when the key is in this
position.
Caution Caution Caution
• Be sure to sit in the seat before turning the key
switch to ON. If the OPS indicator is displayed
on the screen, release the accelerator pedal and
return all levers to their neutral positions. Make
sure that the OPS indicator goes off.
• Do not turn the key switch to ON while depress-
ing the accelerator pedal.
• Remove the key switch when the vehicle is not in
use.
Note:
When the key switch is turned off, the forks will not
lower even if the lift lever is shifted downward (Key-
lift interlock).
Turn signal switch (OPT)
This switch causes the turn lamps to blink.
Left turn ...................... push the lever forward
Right turn ...................pull the lever backward
The turn signals will operate even when the key switch
is off. The turn signal switch returns automatically to
the original position after a direction change.
Light control switch (OPT)
This is two-stage turning switch.
The lights indicated by " " in the table below light up
at each turning position
Light name Step 1 Step 2
Tail lamp (OPT)
Headlight (OPT) –
3
1
2
4
Horn button
Press the button in the center of the steering wheel to
sound the horn.
ARMREST
Note:
If the OPS indicator is displayed on the screen, release
the accelerator pedal, return all levers to their neutral
positions and return to the seat. Make sure that the
OPS indicator is off.
Direction lever
This lever selects forward or backward travel.
The neutral position is between the forward and back-
ward positions.
Forward....................... Push the lever forward
Backward .................. Pull the lever backward
Push the lever in the direction opposite to the traveling
direction, and depress the accelerator pedal to activate
the electric brake for smooth braking.
Caution Caution Caution
• Operate the electric brake carefully when the
forks are loaded.
• Stop the vehicle when shifting to forward or
reverse.
• If the OPS indicator is displayed on the screen,
release the accelerator pedal, return all levers to
their neutral positions and return to the seat.
• There is no directon lever for D2 pedal and Dou-
ble Accel pedal, because these pedals have
switch at acceleration pedal.
Emergency stop button (OPT)
In the event of an emergency, press the emergency stop
button (1) to disconnect power and stop all vehicle
movement (drive and lifting). Pull the button out again
to reset it and restart work.
Do not use the emergency stop button as a power
switch to turn the forklift off.
Horn button (OPT)
Press the button (2) to sound the horn.
Rear assist grip with horn button (OPT)
The rear assist grip with the horn button (4) can be eas-
ily turned on while back running.
19
En
(En-18)