Optional Features - Toyota 8FBE18T Operator's Manual

1
(1) PIN key pad
1 2
3
4
5
(1) Red LED
(2) Green LED
(3) Numerical switches
(4) LOGOFF switch
(5) LOGIN switch

OPTIONAL FEATURES

PIN code entry system (OPT)
With this feature, the key switch is replaced with a ten-
key pad for PIN data entry.
Only operators who have registered PINs (Personal
Identification Number) can activate the vehicle with
this feature. This can contribute to avoidance of irregu-
lar uses by uncertified persons.
PINs range from 4 to 8 figures.
The system has one non-erasable "INITIAL PIN" for
emergency, set by administrators.
This system also can register ten different vehicle set-
tings called "PROFILE", and each PIN can be
assigned one setting out of the ten settings.
Administrators can use this feature to limit various
vehicle performances for safety management, or to fit
the vehicle settings to each operator's favorites.
Caution Caution Caution
PIN code entry is not an anti-theft security system.
Login operation
The operator has to enter the PIN, and then press the
login switch within 10 seconds, to activate the vehicle.
When each numerical key is pressed, the green LED
lights and the buzzer sounds briefly.
The system checks the entered PIN to the registered
PINs after pressing the login switch.
If the entered PIN is certificated, the buzzer sounds
shortly, the green LED lights on and the vehicle acti-
vates.
The profile assigned by the PIN is loaded and the vehi-
cle operates under the settings.
When the entered PIN is not certificated, the buzzer
sounds longer and the system returns to the logoff
state.
Pushing the logoff switch before completing entering a
PIN reset the entered numbers and return the system to
the logoff state.
Logoff operation
The operator can turn off the vehicle by pushing the
logoff switch when the vehicle activates.
At that time, the system turns off the green LED, lights
the red LED for one second, and the buzzer sounds
briefly.
Leaving the vehicle without performing operations for
a period of time (Auto power off setting) also turns it
off automatically.
Protection from password attacks
The system has a protection function from the pass-
word attacks.
This function processes the following operations
depending on counts to enter wrong PINs continu-
ously.
1 - 4 : This function sounds the buzzer and lights the
red LED for 1 second, and also prohibits from entering
new PIN during this period.
5 - 10 : This function sounds the buzzer and lights the
red LED for 5 seconds, and also prohibits from enter-
ing new PIN during this period.
11 - 20 : This function sounds the buzzer and lights the
red LED for 1 minute, and also prohibits from entering
new PIN during this period.
After the counts have reached to 20, the system trans-
fers itself to the lock-mode.
The green and red LEDs blink simultaneously and the
buzzer sounds for 5 seconds if an operator enters any
PIN on this mode.
Only administrators can reset the lock mode.
Before the system has transferred itself to the lock-
mode, it resets the counts to enter wrong PINs when a
correct PIN for operators is entered.
The counts to enter wrong PINs don't increase by
pushing the logoff switch before completing entering a
PIN.
13
En
(En-12)