Screen Functions - Toyota 8FBE18T Operator's Manual

in forward-tilted state
in horizontal state
in backward-tilted state
10 (En-9)
Direction indicator
The pre-set traveling direction (by direction switch) is
indicated.
F ......... Forward
Upward arrow is also shown if vehicle is sta-
tionary.
N......... Neutral
No arrow is shown
R......... Reverse
Downward arrow is also shown if vehicle is
stationary.
Wheel indicator
The indicator indicates traveling direction of the vehi-
cle by " "
Mast tilt indicator
(Multi-function display deluxe only)
The tilt angle of the mast is displayed in unit of 1
degrees.
Note:
When the truck inclines to the front with a heavy load,
the position where 0 degrees are displayed also
inclines to the front.
On the other hand, auto-leveling control compensates
the horizontal position to the back depending on the
detected load.
Therefore, 0 degrees may not be displayed at the
stopped position by auto-leveling control with a heavy
load.
Diagnostic code display
When diagnosis is activated, the spanner indicator
comes on and blinks and a buzzer sounds to warn the
operator that some abnormality has occurred on the
vehicle.
Also, up to six diagnosis error codes are displayed on
the screen.
switch(1) switch(2) switch(3) switch(4)

SCREEN FUNCTIONS

Power select
Every time the switch (2) is pushed in the general
screen, the power select mode will shift to the right in
sequence: S, P, H. When the original mode is selected,
S, P, and H are shown with inverted colors.
Note:
If the administrator sets the menu lock ON, the power
select cannot be changed.
Power control setting function
Press the switch (2) on the general screen for 2 seconds
or more, the power control menu screen will be dis-
played.
Select an item with switch (1), and press switch (4) to
display each setting screen.
Note:
• If the administrator sets the menu lock option ON,
the power control setting menu screen cannot be
displayed.
• This screen is not displayed in the PIN Code Entry
System model.
Travel power control
Select the "DRIVE POWER" on the power control
menu screen to display the drive power control screen.
Switch (2): Select the lower level.
Switch (3): Select the higher level.
Switch (4): Returning to Power control setting menu
screen.
Material handling power control
Select the "LIFT POWER" on the power control menu
screen to display the material handling power control
screen.
Switch (2): Select the lower level.
Switch (3): Select the higher level.
Switch (4): Returning to Power control setting menu
screen.