Page 1
BLOOMFIELD INDUSTRIES 2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439 Customer Service (775) 345-0444 Ext.502 fax: (775) 345-0569 www.wellsbloomfield.com GENERAL OPERATION GUIDE FOR TEA BREWERS Model 8748 Brewer with optional 8602 Server Op600 013102 cps...
FILE CLAIM FOR DAMAGE IMMEDIATELY: Regardless of the extent of the damage. WARRANTY STATEMENT The prices charged by Bloomfield Industries for its products are based upon the limitations in this warranty. Seller’s obli- gation under this warranty is limited to repair of defects with- out charge by a Bloomfield Industries Authorized Service Agency or one of its sub-agencies.
WARRANTY STATEMENT GENERAL USE AND CARE PRECAUTIONS & GENERAL INFORMATION OPERATION CLEANING MAINTENANCE (Deliming) TROUBLESHOOTING SUGGESTIONS Proper installation, professional operation and consistent maintenance of this appliance will ensure that it gives you the very best performance and a long, economical service life. IMPORTANT: This is a general guide only.
3. Do not spill, pour or spray water onto or over any warmers, wiring, controls or control panel. CARE OF STAINLESS STEEL 1. Bloomfield brewers are constructed of high quality stainless steel, As long as the stainless steel surface is intact, the equipment will not rust or corrode.
Disconnect the appliance from electrical power before performing any maintenance or servicing. DO NOT submerge an appliance in water. Bloomfield brewers are not jet stream approved. Do not direct water jet or steam jet at this brewer or at any control panel or wiring. Do not splash or pour water on, in or over any warmer, controls, control panel or wiring.
2. Be sure the wire rack is in place in the bottom of the brew chamber. 3. Insert one (1) genuine Bloomfield paper filter in the bottom of the brew chamber. 4. Pour the proper amount of fresh tea leaves into the brew chamber.
PROCEDURE: Clean Tea Brewer PRECAUTIONS: Disconnect brewer from electric power. Allow brewer to cool. FREQUENCY: Daily TOOLS: Mild Detergent, Clean Soft Cloth or Sponge Bristle Brush. 1. Disconnect brewer from electric power. Allow brewer to cool before cleaning. 2. Remove and empty dispenser. 3.
MAINTENANCE CAUTION - CHEMICAL BURN HAZARD Deliming chemicals are caustic. Wear appropriate protective gloves and goggles during this procedure. Never siphon deliming chemicals or solutions by mouth. This operation should only be performed by qualified and experienced service personnel. IMPORTANT: DO NOT spill, splash or pour water or deliming solution into or over any internal component other than the inside...
Page 9
Run at least three full brew cycles and discard all water generated. 12. Brewer is ready to use. MAINTENANCE (continued) NOTE: Normally, silicone hoses do not need to be delimed. Should deliming hoses become necessary, Bloomfield recommends replacing the hoses.
Allow to cool Reset hi-limit (8786, 8788) Examine wiring & connectors, thermostat and heating element Repair/replace as needed Adjust timer Use one (1) genuine Bloomfield filter per brew Thoroughly clean brew chamber Adjust tea amount Check/reinstall gasket on INSIDE of brew head...
Page 11
NOTES AUTHORIZED BLOOMFIELD SERVICE CENTER CONTACT ADDRESS PHONE #...
Need help?
Do you have a question about the 8748 and is the answer not in the manual?
Questions and answers