Bloomfield 7895T Instructions

10 Sunnen Drive
St. Louis, MO 63143
telephone: 314-678-6336
fax: 314-781-2714
www.wellsbloomfield.com
Disassemble and clean with warm water and mild detergent prior to
use. DO NOT allow the LED sensor to get wet, damage may occur.

Installation

An insulator (white tape) in place to prevent the battery from draining
prematurely. Remove the tape and attach the cover seal as shown
here.
CAUTION
DO NOT use with insulator in place, failure to remove it will prevent
the sensor from working properly.
The cover seal MUST completely cover the hole, without the seal or
if the hole is not completely covered, coffee/water etc, will enter the
hole and cause damage to the decanter.
1. Remove Inner Lid form Body
As in the following, turn the inner lid 90° counter-
clockwise to remove lid.
2. Make sure the sensor is attached, PRE-HEAT the decanter.
Preheat the decanter before its initial use by pouring in some boiling water and letting it sit for 3 minutes.
Dispose of the hot water, before setting under the brewer to receive coffee.
DO NOT place decanter on a HOT warmer, doing so can
damage the unit.
CAUTION
Keep the amount of coffee below the gridline. The sensor detects
the content and the result appears on the LED display a little after
the content is poured in.
p/n SK2646 Rev. -
INSTRUCTIONS
MODEL 7895T
Stainless Steel Thermal Carafe
1 of 1
732
13
732 0423