Electrical Connection - BOMANN EBK 964 Instruction Manual

A: 76 cm
B: 5 cm min.
C: 3 cm min.
D: Air intake
E: Air exit 1 cm
Preparing the worktop for installation of the hob
• The worktop must be at least 3 cm thick and at least 62 cm deep. It must lie horizontally and must be sealed off against overflowing liquids on the
wall side.
• The hob must be framed by at least 5 cm of worktop.
• The cut surfaces (cutout edges) must be sealed with special varnish, silicone rubber, or cast raisin in order to prevent swelling caused by humidity.
• Clean the cutout area of the worktop.
Prepare the cutout of the worktop using the dimensional drawing in "Fig. 2".
NOTE:
Prior to sawing, stick a wide adhesive tape onto the outer edge of the cut-out to prevent jigsaw marks on the worktop.
Attach the sealing to the bottom of the hob frame before installing the hob.
Seal
Installing the hob
• Check the hob sealing for any damage and for correct positioning on the hob.
• Attach the hob to the worktop bottom using the four brackets and screws provided "Fig 3". For that place the hob with the glass side onto an even
surface. Avoid scratches! Place a cushioned support beneath it. Position and adjust the brackets depending on the thickness of the worktop.
• Place the hob with the cable first into the prepared cutout of the worktop. The appliance must be inserted into the cut-out with the control panel
towards the front. Ensure that the distances to the cut-out are the same on all four sides.
Connected wattage
The total power consumption of this device can be up to 3000 W.
With this connected load you need a separate supply line protected by a 16 A circuit breaker (contact gap 3 mm). Please consult your electrician.

Electrical Connection

Fig.1
Fig.2
Fig.3
15 15