Off-Line Installation Model 960 - Sani king Perform-Max 920 Instruction Manual

TOOLS NEEDED
Screwdriver
Pipe Wrench
Battery
Operated Drill
with 5/8" or 19/32"
Bit
MATERIALS NEEDED
Pipe Thread
Sealant
Primer and
PVC Cement
PVC
P ri me r
C emen t
OFF-LINE KIT
Included with the
Perform-Max Feeder
Two Male
Adapters
Two Reducer
Bushings
Two 90
Degree Elbows
Four Hose
Clamps
6' of Tubing
Two
Scoops
Two Scoop
Gaskets
Two Scoop Clamps
Off-line Installation - Model 960
Do NOT install Perform-Max
Feeder Model 960 in-line as this
Perform-Max Feeder is different
than an in-line unit.
1.
P O O
L S A NI
TIZER
P ri me r
PVC
C emen t
3.
Following Primer directions,
brush Primer on reducer
bushings and inside of male
adapters. Repeat this process
with PVC cement following
directions on that product.
SCOOPS
2" – 36" APART
Bi-fl ow valve design allows installation in either fl ow direction.
Following pipe thread sealant
directions, brush sealant onto
Perform-Max Feeder threads
in both ports and on both
male adapters.
DO NOT USE PIPE THREAD
TAPE as the threads
on these units are
not suitable for
this use and
leaking or fi tting
failure could result.
4.
Insert reducer bushing
into male adapter on both sides
with a twisting action. Hold in
place 5 to 10 seconds to bond.
The Perform-Max Feeder
should always be installed
between the fi lter and pool
(or between heater and pool
if applicable). Never install
Perform-Max Feeder before
the heater or damage to the
heater could occur.
OR
2.
Screw a male adapter
into each port of Perform-Max.
Feeder. Hand tighten. Finish
tightening by turning 1 to 2
revolutions with a pipe wrench.
DO NOT
OVER
TIGHTEN.
5.
Following pipe thread sealant
directions, brush sealant onto
elbow threads.
11