In-Line Installation Model 940; In-Line Installation Model 980 For 1½" Plumbing - Sani king Perform-Max 920 Instruction Manual

TOOLS NEEDED
Pipe Wrench
Hacksaw
Tape Measure
MATERIALS NEEDED
Pipe Thread
Sealant
Primer and
PVC Cement
PVC
P ri me r
C emen t
Two 2" Threaded
x 2" or 1 ½" Slip
Male Adapters
(not Included)
Perform-Max 980
Use the 2" x 1 ½" threaded
bushing provided for steps
1 through 3.
Repeat steps 1 through
3 using a 1 ½" threaded
by 1 ½" slip bushing (you
provide). Then follow the
remaining inline installation
instructions.
2" x 1 ½" 1 ½"
Threaded Threaded
Bushing
by 1 ½" Slip
Bushing
10
In-line Installation - Model 940
The Perform-Max Feeder should always be installed between the fi lter
and pool (or between heater and pool if applicable). Never install
Perform-Max Feeder before the heater or damage to the heater
could occur.
Do NOT install Perform-Max
Feeder off-line.
P O O
L S A NI
TIZER
1.
Following pipe thread sealant
directions, brush sealant onto
Perform-Max Feeder threads
in both ports and both male
adapters.
DO NOT USE
PIPE THREAD TAPE
P ri me r
C emen t
4.
Following Primer directions, brush
Primer on the inside of the male
adapters and to ends of pipe.
Repeat this process with PVC
cement following manufacturer's
directions on that product.
OR
Bi-fl ow valve design allows
water fl ow in either direction.
2.
Screw a male adapter
into each port of Perform-Max
Feeder. Hand tighten.
Finish tightening by
turning 1 to 2
revolutions with
a pipe wrench.
DO NOT OVER TIGHTEN.
PVC
5.
Insert PVC pipe into male
adapters with a twisting
action. Hold in place
5 to 10 seconds to bond.
Do NOT install in copper pipe
as chemical corrosion may
lead to pipe failure.
12"
to
Allow a minimum
15"
of 12" above
and on each side
of Perform-Max
Feeder to ensure
room for easy
12" to 15"
access.
3.
Measure the distance between
Perform-Max Feeder male
adapters and cut out a section
of pipe 3" less than that
dimension.
HEATER
FILTER
(If
PUMP Installed)
6.
To prevent damage to heaters
or fi lters, install a corrosion
resistant check valve which will
reduce the back fl ow of chlorine
gas when the feeder is turned off.
7. For better
stability,
P O O
Perform-Max
Feeder may
be mounted
on a treated
wood base
using Phillips
pan head screws, one in
front and one in back. If
you have questions about
stability, please contact your
dealer or King Technology.
*CHECK
VALVE
L SA NIT
IZER