Gpib-Enet/1000; Gpib-Enet/1000 Installation - National Instruments GPIB-USB Series Hardware Manual

GPIB-ENET/1000

GPIB-ENET/1000 Installation

9
1 Front Panel LEDs
2 GPIB Cable
3 Power Cord
© National Instruments
Follow these steps and refer to Figure 1-10 to install the
GPIB-ENET/1000:
1. Connect one end of your Ethernet cable to your GPIB-ENET/1000.
Connect the other end of the Ethernet cable to your Ethernet network.
2. Connect one end of the power cord to the power supply. Screw the
power connector on the other end of the power supply onto the power
jack of the GPIB-ENET/1000.
3. Plug the other end of the power cord into an AC outlet.
1
7
6
8
4 Power Supply
5 Ethernet Connector
6 Power Connector
Figure 1-10. Installing the GPIB-ENET/1000
4. Refer to the Baseplate Identification Label
GPIB-ENET/1000 and make a note of the serial number, MAC address
(Ethernet address), and default hostname. You will need this
information when you run some of the utilities.
5
4
7 Configuration Reset Switch
8 Ethernet Cable
9 To Ethernet Network
1-25
Chapter 1 GPIB Hardware
2
3
on the base of the
GPIB Hardware Guide