Lenovo DM120S Service Manual page 13

1
c. Lower the drive straight down, and then rotate the cam handle down until the drive snaps into
place under the orange release latch.
d. Carefully push the drive drawer back into the enclosure.
e. Close the drive drawer by pushing both levers towards the center.The green Activity LED for
the replaced drive on the front of the drive drawer comes on when the drive is inserted
correctly.
Step 8. If you are replacing another disk drive, repeat Steps 4 through 7.
Step 9. Check the Activity LED and the Attention LED on the drive you replaced.
LED status
The Activity LED is on or blinking, and the
Attention LED is off
The Activity LED is off
The Attention LED is on
Step 10. If you disabled disk ownership automatic assignment in Step 1, manually assign disk ownership,
and then reenable disk ownership automatic assignment if needed:
Display all unowned disks:storage disk show -container-type unassigned
a.
Assign each disk: storage disk assign -disk disk_name -owner owner_name You can use the
b.
wildcard character to assign more than one disk at once.
Raised button on the right side of the drive carrier
Attention: Possible loss of data access – Never
slam the drawer shut. Push the drawer in slowly to
avoid jarring the drawer and causing damage to the
storage array.
Description
The new drive is working correctly.
The drive might not be installed correctly.
Remove the drive, wait 30 seconds, and then
reinstall it.
The new drive might be defective. Replace it
with another new drive.
Note: When you first insert a drive, its
Attention LED might be on. However, the LED
should go off within a minute.
.
Chapter 2 Hot-swapping a disk drive in a DM600S disk shelf
9