Factorydefault'command; Save'command; Exit'command - Sena HelloDevice Lite Series User Manual

par1 = PPPoE username,
par2 = PPPoE password

2.4.4 ' factorydefault'Command

With ' factorydefault'command, users can load factory default parameter values in console. Command
usage of ' factorydefault'is as follows:
factorydefault [option] + <CR>
where,
- if option is omitted, all parameters are set with factory default values.
- if option='-ip', all parameters except IP settings are set with factory default values.
Loaded values are not saved until ' save'command invoked. After ' factorydefault"command, ' save'and
' reboot'commands are required for changes to take effect.
> factorydefault (or factorydefault –ip)
OK
> save
OK
> reboot

2.4.5 ' save'Command

With ' save'command, current parameter changes are saved to non-volatile memory. Command usage
of ' save'command is as follows:
save + <CR>
Saved changes will be applied if the LS100W is rebooted by ' reboot'command or manual rebooting.

2.4.6 ' exit'Command

With ' exit'command, current serial or remote console session will be closed. However, changed
parameters are not applied until the LS100W is manually rebooted. Command usage of ' exit'
command is as follows:
exit + <CR>
Figure 2-15 Help screen with ' ip'group specified
Figure 2-16 Factory default reset screen
21