Sena HelloDevice Lite Series User Manual page 39

Or
[Listen] --> [Sync-Sent] --> [Established] --> [Data] --> [Closed] --> [Listen]
The initial state is [Listen]. If there are data coming from the serial port, it will connect to the remote
host as a TCP client. If there is incoming connection request from the remote host, it will accept the
connection as a TCP server, and then transfer data through the serial port. Thus, users can assume
that the LS100W is always connected to the specified remote host.
2) Operations
The only difference from TCP server mode is that the LS100W will try to connect and send serial data
to the remote host even if the TCP session is not established. The difference from TCP client mode is
that it will accept incoming connection request from remote host if the session is not established. The
detailed operation principles are the same as that of TCP server and TCP client mode.
Established
Figure 5-5. State Transition Diagram of TCP server/client mode
Sync-Sent
TCP connection request accepted
Incoming data via serial port
Incoming data
from remote host
Accept
Sync-Recvd
Incoming data via serial port
TCP connection request rejected
Or internal TCP time-out
In-coming TCP Close request
Inactivity time-out
Data
Reject
Incoming TCP connection request
39
Closed
Listen