Speakman SC-3084-LD Instructions

INSTRUCTIONS FOR MODELS
SC-3084-LD
SC-3084-LD-E
For additional assistance or service please contact:
SPEAKMAN
®
Company
400 Anchor Mill Road
New Castle, DE 19720
800-537-2107
customerservice@speakman.com
www.speakman.com
92-SC-3084-LD-R1

TOOLS AND SUPPLIES

Adjustable Slip Joint Phillips Silicone
or Sealant
Wrench Wrench Screwdriver
HELPFUL TOOLS & SUPPLIES:
Supply Solder Kit Tubing Basin
Hoses Cutter Wrench
Thread Seal
Tape

IMPORTANT

Do not overtighten any connections or damage
may occur.
•This installation manual covers several models.
While the appearance of your faucet may vary, the
installation steps required are the same as shown in
this manual.
•Be sure to read instructions thoroughly before
beginning installation.
•This faucet has an operating range of 20-80 psi.

SAFETY TIPS

Cover your drain to prevent loss of parts. Be sure to
wear eye protection while cutting pipe.

MAINTENANCE

Your new Lavatory Faucet is designed for years of
trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. Avoid
abrasive cleaners, steel wool, and harsh chemicals
as these will dull the finish and void your warranty.

WARRANTY

Additional warranty information can be found at:
www.speakman.com
1
Unthread and remove one trim collar to verify the
cold or hot valve. The cold valve will be marked
BLUE, and the hot valve will be marked RED.
Orient the faucet base so the "BLUE" valve is on
the right hand side. Reinstall the Trim Collar.
BLUE
2
Apply Silicone or sealant to base of faucet.
3
Position faucet onto mounting surface and press
down firmly to set the sealant.
4
From beneath sink, install Cup Washers (1) and
Shank Nuts (2) onto Shanks of Faucet. Wrench
tighten. From above sink remove excess sealant
from around the base of the faucet.
5
Connect water supplies to faucet inlets
(½-14 NPSM) and wrench tighten.
NOTE: Supply Lines and Shut-Off Valves not included.