Table of Contents
Advertisement
INSTALLING & CLEANING FOAM
SLEEVE FILTER
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the mains
power source.
2. Remove power head and place in upside down position.
3. Carefully slide foam sleeve filter down over the filter cage
making sure the hole is covered. (Fig. 35)
4. Replace the power head on to the tank.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position,
carefully remove foam sleeve filter. (Fig. 36)
2. Use a mild soap and water solution to wash foam sleeve
filter and rinse with clean water. (Fig. 37)
3. Allow filter to air dry before installing and using again.
Fig. 35
Fig. 37
INSTALLING & CLEANING EXHAUST
FILTER
1. Verify that the power cord is disconnected from the mains
power source.
2. Push the exhaust cover lock upward and remove the
exhaust cover. (Fig. 38 & 39)
3. Take out the exhaust filter and clean it carefully with a soft
brush. (Fig. 40 & 41)
4. After cleaning, fit the exhaust filter and exhaust cover back
on to the power head. (Fig. 42 & 43)
5. Push down the switch to lock the exhaust cover. (Fig. 44)
Fig. 36
HOW TO CHANGE DUST BAG AND
FILTERS
Change the dust bag
When the collection bag is 3/4 full, it MUST be replaced.
Excessive over filling of this bag makes it difficult to remove
from the vacuum tank and can result in breakage and spills.
The collection bag comes equipped with a quick closing flap.
When collection bag becomes 3/4 full, turn off vacuum and
slowly remove the collection bag from the tank until the
opening in the collection bag is clear of the tank. Pull the
closure slide up on the collection bag, which will close the
opening.
9
Fig. 38
Fig. 40
Fig. 42
Fig. 44
Fig. 39
Fig. 41
Fig. 43
Hide quick links:
Advertisement
Table of Contents
