Installation Instructions - Mistral MPP274S Installation Manual And User's Manual

2. INSTALLATION INSTRUCTIONS
Tools and Parts
Gather the required tools and parts listed below before starting installation. Read and follow the instructions
Required tools

Level

Drill

Drill bit of 1/8'' (3 mm)

Pencil

Pliers

Measuring tape or ruler
Necessary parts

Round metal drain pipe system of 6" (15.2 cm) in diameter
Location requirements
Observe that all local and National codes and regulations are met
IMPORTANT:
Entrust the installation of the hood to a qualified installer. It is the installer's responsibility to respect the
separation clearances specified on the nameplate of the unit. The unit's rating plate is located behind the filter
on the left rear wall of the hood. Install the range hood away from any area that is exposed to drafts, such as
windows, doors and heating vents.
Follow the dimensions indicated for openings to be cut in cabinets. These dimensions provide a minimum
clearance. Before making cut-outs, refer to the instructions of the cooktop or range, above which you will place
the hood.
The location must be equipped with a grounded electrical outlet. See ''Electrical Specifications'' for more
information. The hood is configured for installation with a discharge to the outside through the roof or wall.
Make sure to seal each opening cut in the ceiling or wall for the installation of the range hood.
Installation in a mobile home
The installation of this range hood must meet the requirements of national and local standards and codes.
Dimensions
of the unit
A
B
C
D
- Caulking gun and waterproof caulking compound
- Flat-bladed screwdriver
- Jigsaw or reciprocator saw
- Phillips screwdriver
- Duct flanges
- Tin snips
Built-In Hood 27.6'' (70.1 cm)
Dimension
27 1/2'' (68.6 cm)
26'' (66 cm)
5/8'' (1.6 cm)
10 1/4'' (25.4 cm)
Dimension
E 9 7/8'' (25.1 cm)
F 5/8'' (1.6 cm)
G 12 3/8'' (30.43 cm)
H 6'' (15.25 cm)
5
.
.