Mistral MPP274S Installation Manual And User's Manual page 12

Discharge toward the exterior, through the wall
1. Attach the transition 6'' (15.25 cm) duct at the top of the body of the hood using two 3.5 x 9.5
mm screws. Assemble the exhaust duct to be used on the 6'' (15.25 cm) transition fitting duct.
2. Measure the distance between the bottom of the body of the hood and the horizontal centerline
of the discharge opening (A).
Mesure 'A'
A.
Central axis
B.
Circular cut-out opening of 6 ¼'' (15.9 cm)
C.
3. Remove the vent pipe from the body of the hood. See dimension A on the back wall of the cabinet.
Take measurements from the bottom of the cabinet.
4. Mark the perimeter of the opening to be cut out - see illustration. Use a jigsaw or reciprocator
saw to cut a circular hole through the back of the cabinet and exterior wall for evacuation.
Connecting the exhaust system
Venting to the exterior
Connect the exhaust system to the discharge opening of the hood. Tighten the connection points with
flanges.
Completing the installation
1. Re-install the grease filters. See ''Range Hood Care".
2. Plug the 3-pin power cord into the 3-prong grounded outlet located in the cabinet that is above
the hood.
3. Check the fan hood and lamp. See "Using the hood" section. If the hood does not work,
determine if a circuit breaker has tripped or a household fuse has blown. Disconnect the power
source and inspect the wiring connections
To take full advantage of the new range hood, please read the section "Operating the hood".
NOTE:
Electrical Shock Hazard
Plug into a 3-prong grounded outlet.
Do not remove the connecting pin to the ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, a fire or electric shock.
A
B C
WARNING
.
12