Advertisement
10200378GB.fm Page 22 Wednesday, March 5, 2008 12:50 PM
Column oven installation
Important notes
Important: Make sure to disconnect the oven from the power supply before carrying out any
installation or maintenance work on the appliance.
• Installation must be carried out by a qualified technician in compliance with the manufacturer's
instructions and local safety regulations.
• After unpacking the oven make sure it was not damaged during transport and that the door closes
properly. In the event of problems, contact the dealer or your nearest After-Sales Service
Centre.
• After unpacking the oven, leave it on the polystyrene base: this will prevent any damage to the
appliance.
• It is advisable to wear protective gloves when installing the appliance.
• The oven is provided with two side handles
Preparing the housing unit
• Kitchen units next to the oven must be heat resistant (min. 80 °C).
• Carry out all cabinet cutting work before fitting the appliance in the housing. Ensure you remove all
wood chips and sawdust, which could hinder correct appliance operation.
• For installation as shown in Fig. 2, recipients containing liquids must not be placed on the top part of
the column unit. Grilles can be applied to partly close the opening, in any case maintaining a working
area of 100 cm2.
• The dimensions of housing units are given in figures 1, 2 and 3. Oven dimensions are given in fig. 4.
• To ensure adequate ventilation, leave an open space at the back of the housing (observing the
dimensions given in Fig. 6). After installation, the bottom of the oven must no longer be
accessible.
• Install the oven making sure its walls do not directly touch the adjacent kitchen units (Fig. 5).
22
(B) to facilitate installation (Fig. 7).
1
2
3
4
Advertisement
