Table of Contents
Advertisement
AUDIO DUBBING
Aduio dubbing i s used to record narration or music
6.
The sound to be recorded may be Television
on prerecorded tapes.
Sound, Audio connected to the "AUDIO IN"
jack or from a microphone connected to the
1.
Turn ON the "POWER" switches of the VCR
"MIC" jack.
and TV receiver.
7. Press the "PLAY" button.
2-
Set
the
TV
channel selector
the VCR
8. When the tape comes to the point where you
CHANNEL (Channel
3
or 4).
want to dub the sound, press the "PAUSE/
3.
Insert the cassette into the compartment.
ST1 LL" button.
4. Set the "TV/VCR"
switch to "VCR" posi-
9. Then press the "AUDIO DUB" button.
tion.
10. Press the "PAUSE/STILL" button again to
5.
Set the "INPUT" selector switch to "LINE"
start the dubbing.
position.
11.
Press the "STOP" button to stop the dubbing.
Note: Sound is recorded on the conventional
horizontal Monaural Track (See page
33.)
EDITING RECORDING
1.
Push "PLAY" button and watch the program
4. When you want to begin recording, push the
until the exact point i s reached where you
"PAUSE/STILLW button again.
The new
want the new recording to begin.
program material will directly follow the
2.
-Push the "PAUSE/STILL" button. Then- the
previously recorded material without interrup-
television screen will display the s t i l l picture.
tion. This feature i s especially helpful during
3. Push the "REC" button. Then the program
camera use,
s o
each segment of the recording
material t o be recorded will appear on the
becomes a.continuous program.
television.
Advertisement
Table of Contents
