Rest - K-Systems G95 Instruction Manual

To change back to temperature
Action
Press and hold setpoint key .
Press the HEAT key one time, then let go of
the setpoint key.
The display now shows the temperature.
Note The time is shown as a 24 hour clock e.g 19.30 not 7.30 PM.

REST

The REST function will restore all factory set values.
Any changes made to the displayed temperature, unit readings and controller value will be reset.
Note Calibration value in the TUNE option will remain and not be reset.
Follow these steps to navigate in the REST option.
Action
Press and hold UP+DOWN key for 3
seconds to enter the the menu.
The option "UNIT" will appear in the
display.
Press DOWN key until the option "REST"
appears in the display.
Press and hold setpoint key to change
values.
While holding the setpoint key in, press
either the arrow UP or DOWN key.
When the display shows "----", * let go of
the setpoint key.
Press and hold UP+DOWN key for 3
seconds to exit the the menu.
*This means all factory values have now been restored
Key
Key
Page 22
Instruction manual - G95
Display
Display
Kivex Biotec Ltd