Rest - K-Systems G85 Instruction Manual

To change back to temperature.
Action
Press and hold setpoint key.
Press the HEAT key one time,
then let go of the setpoint key.
The display now shows the
temperature.
Note The time is shown as a 24 hour clock e.g 19.30 not 7.30 PM.

6.11 REST

The REST function will restore all factory set values.
Any changes made to the displayed temperature, unit readings and controller value will be
reset.
Note Calibration value in the TUNE option will remain and not be reset.
Follow these steps to navigate in the REST option.
Action
Press and hold UP+DOWN key for
3 seconds to enter the menu.
The option "UNIT" will appear in
the display.
Press DOWN key until the option
"REST" appears in the display.
Press and hold the setpoint key to
change values.
While holding the setpoint key in,
press either the arrow UP or arrow
DOWN key.
When the display shows "-----", *let
go of the setpoint key.
Press and hold UP+DOWN key for
3 seconds to exit the menu.
*This means all factory values have now been restored.
Key
Key
26
Instruction Manual - G85
Display
Display