Barrel Blocking Device Installation Instructions - Tippmann STORMER BASIC Quick Start Manual

E
N
G
L
This is not a toy. Misuse may cause serious injury or
I
death. Eye, face, and ear protection designed for paintball
S
must be worn by the user and any person within range.
H
We recommend you be at least 18 years old to purchase.
Persons under 18 must have adult supervision when using
this product. Read the Owner's Manual before using this
product.
Always keep the barrel blocking device installed except
when your marker is in use. Always make sure that the
Selector Switch is in the Safe mode (see instructions
on page 6) and the barrel blocking device is properly
installed on your marker according to the instructions to
prevent damage to property, serious injury, or death.

Barrel Blocking Device Installation Instructions

1. Insert the barrel blocking device onto the Barrel and loop
the cord over the top of the receiver and position at the
back of the grip as shown.
2. Adjust the cord length retainer up to the back of the grip
by pulling the cord through it until the retainer is snug
against the back of the grip. Keeping the cord as tight
as possible, leave just enough cord elasticity to pull the
cord/retainer up over the top of the marker to remove the
barrel blocking device for firing.
3. After the cord length is properly adjusted, lock the cord
length by tying a knot in the cord against the back of the
retainer as shown.
4. Before and after playing, inspect the barrel blocking device.
Replace the barrel blocking device if the sleeve or cord is
damaged, or there is a loss of cord elasticity.
5. Clean the barrel blocking device with plain, warm water and store out of sunlight in a dry
area when not in use.
4
WARNING
WARNING
Barrel Blocking Device
Cord Length
Retainer
Quick Start Guide Rev. 12/19