BAYTEK GAMES SQUIGGLE Service Manual page 44

Use a can of air to spray in the small holes in the top of the tube.
This should remove any debris that has accumulated on the sensor.
The Drop Button is accessed from the top of the control panel.
To remove and replace:
1.) Remove all of the small black Phillips screws.
2.) Remove the 4 Phillips screws.
3.) Drop button can now be removes and replaced.
4.) Re-installation is the reverse of removal.
The Drop Button is accessed from the top of the control panel.
The Drop Button is accessed from the top of the control panel.
To remove and replace:
To remove and replace:
1.) Remove all of the small black Phillips screws.
1.) Remove all of the small black Phillips screws.
2.) Remove the 4 Phillips screws.
2.) Remove the 4 Phillips screws.
3.) Drop button can now be removes and replaced.
3.) Drop button can now be removes and replaced.
4.) Re-installation is the reverse of removal.
4.) Re-installation is the reverse of removal.
To remove the Ball Tube, the front protective cover must first be removed.
To remove the Ball Tube, the front protective cover must first be removed.
To remove and replace:
To remove and replace:
1.) Remove the 4 Phillips screws on the left side of the blue metal.
2.) Remove all of the small Phillips screws on the right side of the clear plexi.
1.) Remove the 4 Phillips screws on the left side of the blue metal.
3.) Remove the cover and set aside for later installation.
2.) Remove all of the small Phillips screws on the right side of the clear plexi.
3.) Remove the cover and set aside for later installation.
4.) Remove the 2 of #2 square bit screws.
To remove the Ball Tube, the front protective cover must first be removed.
5.) Lower the black plastic, lift tube up and out of cabinet.
4.) Remove the 2 of #2 square bit screws.
To remove and replace:
6.) Clean or replace if needed. Part # A5PI6500
5.) Lower the black plastic, lift tube up and out of cabinet.
1.) Remove the 4 Phillips screws on the left side of the blue metal.
7.) Re-installation is the reverse of removal.
6.) Clean or replace if needed. Part # A5PI6500
2.) Remove all of the small Phillips screws on the right side of the clear plexi.
3.) Remove the cover and set aside for later installation.
7.) Re-installation is the reverse of removal.
4.) Remove the 2 of #2 square bit screws.
5.) Lower the black plastic, lift tube up and out of cabinet.
6.) Clean or replace if needed. Part # A5PI6500
HOW TO
HOW TO
CLEAN COLOR SENSOR
CLEAN COLOR SENSOR
HOW TO
REPLACE DROP BUTTON
HOW TO
HOW TO
HOW TO
REPLACE DROP BUTTON
REPLACE DROP BUTTON
REPALCE DROP BUTTON
HOW TO
HOW TO
HOW TO
REMOVE BALL TUBE
REMOVE BALL TUBE
REMOVE BALL TUBE
HOW TO
REMOVE BALL TUBE
44