Troubleshooting - BAYTEK GAMES SQUIGGLE Service Manual

Problem
Unplugged.
No power to the
Power strip turned off,
game
or plugs unplugged.
Circuit breaker tripped.
Line filter faulty.
Bad or overloaded power
supply.
Power supply unplugged.
Bill Acceptor on,
Rocker Switch on power
no signal on
supply is Off.
monitor, but
everything else
Power supply shutting
off
down because of 12 V
(Power Supply
overload.
not ON)
Faulty power supply.
LED strip faulty
Marquee LED
Faulty Cable
lights are not
working
LED strip faulty
Drop Button
LED's not
working
Faulty Cable
(
Power goes
through RGB
Control Light Board) Faulty RGB Control Light
Board
Drop Yellow Ball LED strip faulty
center ball drop
not
Working
(
Faulty RGB Control Light
Power goes
through RGB
Board
Control Light Board)
Faulty Earlier Component
Ball Light
color LED
Extra 12 Volts to LED
Board not
working
LED strip faulty
(
Power goes
Faulty Cable
through Edge
LEDS's first,
coming from I/O
Faulty I/O Aux Board
Aux Board)

TROUBLESHOOTING

Troubleshooting Guide
Probable Cause
Faulty Cable
Check wall outlet cable
(A5CORD5)
in back of game. Check AACE6529 cable to power strip.
Check rocker switch on power strip. Ensure
power cords are pushed up into power strip securely.
Reset power strip breaker switch or building
circuit breaker. Attempt to determine cause.
Replace line filter. (A5FI9010)
Refer to Power Supply Diagnostics
Insure power supply is plugged into power strip.
Make sure rocker switch is set ON.
See power supply diagnostics to isolate bad component.
A bad solenoid or 12 volt short would cause this.
Refer to Power Supply Diagnostics section.
Remove marquee and examine LED strip. (AACE6542)
Check cables from LED strip to power distribution board.
(AACE6542, AACE6533, AACE6500)
Open front door and examine circuit board with LED's.
Replace if needed. (AACE6541)
Check cables from LED board to RGB Control Board
(AACE6541, AACE6504)
Swap cables to a different socket on the board. Replace
RGB Board if needed. (Part # AACB6502)
Examine LED strip. There should be 12 Volts present.
Replace LED strip if needed. (AACE6555)
Check cables from LED strip to RGB Control Board
(AACE6556)
Swap cables to the different socket on the board. Replace
RGB Board if needed. (Part # AACB6502)
Signal first goes through the outside edge colored lights.
Ensure these outside edge lights are functioning properly
Make sure 12 volts is being back-fed through AACE6507
Examine LED board. Replace LED board if needed.
(AACE6552)
Check cables from LED board to I/O Aux Board
(AACE6511, AACE6519, AACE6510)
Swap cables to a different socket on the I/O Aux board.
Observe if the problem changes to the center track LED's
Replace I/O Aux Board. (Part # AACB9601-SQ)
31
Remedy
to line filter
(A5FI9010)