Health O Meter 2595KL User Instructions page 7

2595KL ASSEMBLY INSTRUCTIONS
Assembly Instructions (Refer to Figures 1- 3)
Note: Do not attach the AC adapter at this point. Wait until Step 9.
Caution: It is recommended that the assembly be performed by two persons.
1. Remove the chair scale assembly from the carton and place chair scale on a flat, level
and dry surface.
2. Pull forward on the handrail to tip the scale over, and gently place it face down on the floor.
3. Thread the (2) leveling feet into the underside of the chair scale assembly. Each foot should
be completely hand tightened.
4. Position the casters and caster brakes on both sides of the chair assembly.
5. Position the caster and caster brake with each bolt hole. Place the bolt through each bolt
hole and tighten using the 3/16" (5mm) Allen wrench (see Figure 3).
Note: Ensure caster brake is positioned with one tab on the exterior of the caster.
6. Carefully tilt the scale back to an upright position on the floor.
Warning: Do not drop scale, as this can permanently damage the load cells.
7. Adjust the feet to level the scale.
8. Connect the AC adapter to the power port in the display assembly. Do not plug the scale
into a power source until the scale is fully assembled.
Note: The scale may be operated by an AC adapter (included), or by 6 C-cell batteries (not
included). Using the battery option, unplug the AC adapter from the adapter jack and ensure that
there are 6 C-cell batteries in the display assembly. The scale will automatically switch to battery
power when the AC adapter is absent or not plugged in.
9. The scale is now assembled. Plug the AC adapter into a power source and / or insert
batteries. (See page 9 for battery installation).
P/N UM2595KL_REV20200128
7