Page 1
Outdoorsman REQUIRED TOOL: 3/4” wrench crossbar sold separately ADDITIONAL PAIR sold separately.
Page 2
APPLY PADS TO INSIDE OF BRACKETS. • Peel pad from • Be sure to match pad size backing material. to surface size. Position bracket tube inside truck bed. Clean surfaces Determine where the where brackets brackets will be will be installed. installed on the truck bed rails.
Page 3
INSTALL SECOND BRACKET. Match the position of the first bracket. Measure from edge of bed to the bracket for best results. Do not tighten second bracket until crossbar is installed. INSTALL THE CROSSBAR (purchased separately). If the bar appears to be at an awkward angle to the rack, loosen the anchor bolt slightly to permit loading.
Page 4
SYSTEM LOAD LIMITATIONS BRACKETS PAIRED WITH ANOTHER SYSTEM: TWO SETS OF BRACKETS: Always follow the weight limit of Maximum Weight Limit the lighter system. 300 lbs. / 135 kg Secure front and rear of long NOT RECOMMENDED loads to ends of vehicle for FOR USE WITH DRIVE safe transport.