Yakima RidgeBack 2 Installation Instructions Manual

Yakima RidgeBack 2 Installation Instructions Manual

Car bike rack
Hide thumbs Also See for RidgeBack 2:

Advertisement

ZipStrip™ (6X)
ZipStrip™ (12X)
ZipStrip™ (15X)
FRONT WHEEL STRAP (1)
SAFETY STRAP (1)
RidgeBack 4
RidgeBack 2, 5 (not shown)
KEY (2X)
M5 WRENCH (1X)
M4 WRENCH (1X)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RidgeBack 2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Yakima RidgeBack 2

  • Page 1 RidgeBack 4 RidgeBack 2, 5 (not shown) KEY (2X) M5 WRENCH (1X) ZipStrip™ (6X) ZipStrip™ (12X) ZipStrip™ (15X) M4 WRENCH (1X) FRONT WHEEL STRAP (1) SAFETY STRAP (1)
  • Page 2 PURCHASE SEPARATELY TubeTop TubeTop Required for bikes with step-through/Ladies frames or bikes with slanted top tubes. Part #8002531 HandCuff HandCuff Adds a locking cable to carrier. Part #8002466 HitchSki HitchSki (RidgeBack 4&5 only) Carries up to 6 pairs of skis or 4 snowboards Part #8002418...
  • Page 3 2” 1 ” 1034500B-3/8...
  • Page 4 10 ft-lbs A Yakima TubeTop (see cover page) may be required to carry your bike safely. Failure to load bikes properly can result in property damage, personal injury, or death. Bikes should be as level as possible to avoid ground clearance issues and possible ejections.
  • Page 5 1034500B-5/8...
  • Page 6 FOLD MAST DOWN TO ACCESS THE REAR. REMOVAL 1. Remove safety strap. 2. Unload the bikes. 3. lower the arms. 4. Unlock the carrier. 5. Loosen red knob. 6. Remove the hitch pin. 7. Remove the carrier from the hitch. 8.

This manual is also suitable for:

Ridgeback 4Ridgeback 3

Table of Contents

Save PDF