Installation Procedure - Rinnai Enduro XL SP250B Operation & Installation Manual

INSTALLATION PROCEDURE

Collector overhangs
cylinder on this side
Rinnai
33 1
Collector and cylinder
to sit flush on this side
21
1� Position rails on roof in suitable
location and fasten to roof using
suitable fasteners�
Ensure rails are not sitting in
lower channels of roofing profile�
Adjust angle slightly in necesary,
ensuring orientaion still complies
with any regulations�
2� Position cylinder on rails and
fasten in four locations using
screws and washers�
3� Place collector on cylinder and
rails� The collector should be
supported by the cutout in the
rails until it is secured�
Low Profile Roof Mounted OIM
INSTALLATION
33 4
5
4
33
33 5
33 2