Advertisement
3
BED ASSEMBLY (continued)
6. Align the holes of the front axle assembly with the
three holes remaining on the wagon bed frame.
7. Secure in place using three (3) M12x18 hex bolts,
three (3) M12 flat washers, and three (3) M13
locknuts as shown diagram C.
8. Slide handle coupler between ends of the yoke.
Position the handle as desired and slide handle end
into handle coupler. Align all holes.
9. Insert M12x60 bolt through all three parts and
secure with a M12 flat washer and M13 locknut as
shown in diagram D.
10. Verify all connections are tight and turn wagon onto
its wheels.
NOTE: Periodically check connections to make sure
they are tight and secure.
11. Return to all wheel acorn nuts and tighten.
12. Check tire pressure and adjust as needed.
Parts List and Tools Required
Flat Screwdriver
Socket/Wrench Set
Pliers
Revision date: 05.30.19
M12 Washers (4)
M12x60 Hex Bolt (1)
C
Circles show where the front axle assembly attach to the bed
support.
Yoke
D
Slightly tighten
bolt so the handle
pivots freely.
M12x18 Hex Bolts (3)
CARTS AND WAGONS
Handle Coupler
Bolt
Washer &
Locknut
M13 Locknuts (4)
Handle Coupler (1)
7
Advertisement
