Advertisement
1
BACK WHEEL ASSEMBLY
NOTE: Hardware may ship attached to parts.
To better align the wagon, do not fully tighten
the nuts and bolts until the entire wagon is
assembled.
1. If needed, remove locknuts and large
washers from the rear axle support.
2. Slide left and right rear axle braces onto the
axle of the rear axle support.
NOTE: The spacer of the axle brace should
face away from the axle support as shown
below.
3. Slide on one (1) wheel, large washer, and
locknut on each side of axle as shown in
diagram B. Do not tighten at this time.
A
Spacer
positioned
away from
axle support.
Parts List and Tools Required
Socket/Wrench Set
Flat Washers (2)
Pliers
Revision date: 05.30.19
Rear Axle Braces
Rear Axle Support
Locknuts (2)
B
Flat washer and locknut are used on the outside
of the wheel.
Rear Axle Braces (2)
CARTS AND WAGONS
Rear Axle Support (1)
Wheels (2)
3
Advertisement
