Schaudt LRM 1218 Installation Instructions Manual page 5

Solar regula- Connection to battery
tor
LRM 1218 Via EBL with 3-pin
connection, 2 pins assigned;
the following solar regulator
connector is in the block
diagram (E is either not
assigned or routed in the
EBL to an input for a solar
module); A is used here as
an input for the leisure area
battery:
3F MNL socket
to LR(M) solar charge regulator
[+] A (LAB)
[- -] Negative
Solar
charge regulator
Via bus-compatible EBL; the
following symbol might be on
the front panel:
Directly on the vehicle for
third party systems or EBLs
without solar regulator con-
nector
LR 1218 Via EBL with 3-pin connector
(EBL connection diagram as
for LRM 1218; see above). for LRM 1218; see above)
Via EBL with 3-pin
connector, 2 pins assigned
(EBL connection diagram as
for LRM 1218; see above).
Directly on the vehicle for
third party systems
Via bus-compatible EBL;
symbol specified as for LRM
1218
* Dual display of solar power in Normal mode; but display option also for active shutdown. Refer to Section
7.3.
9990314 MA / EN
Installation Instructions Solar systems (controller and panel)
Display
Via LT 320
EBL ...
3 3
2 2
(E)
1 1
Via bus panel with solar
power display
Via LT 320*
LT 320
LT 320
Display panel with solar
power display, e.g.
LT 320
LT 320
Via LT 320
Date: 20.09.2018
Bus system  See
--  Section
5.3
SDT 213  Section
7.2
SDT 630  Section
SDT 213 7.3
--  Section
5.1
--  Section
5.2
--  Section
5.4
--  Section
5.3
--  Section
5.1
SDT 630  Section
SDT 213 7.1
5