General And Application - Schaudt LRM 1218 Installation Instructions Manual

Installation Instructions Solar systems (controller and panel)
Solar regula- Connection to battery
tor
LRM 1218 Via EBL with 3-pin
connector; the following solar
regulator connector is in the
block diagram:
3F MNL socket
to LR(M) solar charge regulator
[+]
[- -]
Solar
charge regulator
LR(M) 1218
Solar module
[Solar module]
3F MNL socket
to LR(M) solar charge regulator
[+]
[- -]
Solar
charge regulator
LR(M) 1218
LAB signal
SB signal
Solar module
[Solar module]
Pin strip MSFQ/0- -4F
to LR(M) 1218 solar charge regulator
4
4

General and application

This document describes the connection of Schaudt products developed for
solar systems:
LRM 1218 solar regulator*
F
LR 1218 solar regulator
F
LT 320 control and display panel
F
* the solar regulator LRM 1218 was delivered with two different housing ty-
pes. The connection is the same for both types.
Which devices are to be fitted new and the situation inside the vehicle must
be known before work is commenced. Then the corresponding connection
diagram must be determined and the connectors established in the form
shown therein:
EBL ...
3 3
+LAB
2 2
+SB
1 1
Negative
EBL ...
3 3
+LAB
2 2
+SB
1 1
Negative
1 1
2 2
3 3
4 4
Display
Via LT 320
Via panel with solar power
display
Date: 20.09.2018
Bus system  See
--  Section
5.2
--  Section
5.4
9990314 MA / EN