Table of Contents
Advertisement
Hook the cooker hood into the bearings,
then adjust vertically and horizontally the
position of the appliance, acting on the spe-
cial regulating metric screws.
The air outlet of the product is oriented up-
wards: in the case that one prefers the air
outlet towards the rear side of the appliance
, it is only necessary to replace the air rele-
ase piece with the other one supplied with
the appliance.
8
In the 30" version, it is possible to orient the
air outlet towards the rear side of the cooker
hood by rotating the sucking unit.
Remove the fixing screws shown,
take the sucking unit out, rotate and reinsert it
into the desired position, and then place again
the screws that had been removed. To comple-
te installation, insert the two fixing screws into
the rear side of the cooker hood, into the two
holes that were created beforehand. Before fi-
xing the chimney in place, place the electrical
feeding equipment into the decorative pipe as
well as the related electrical connection.
Advertisement
Table of Contents
