Related Manuals for Stryker SR-655HPC
Summary of Contents for Stryker SR-655HPC
- Page 1 For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com) 8312 Sidbury Rd. Wilmington, NC 28411 (800) 507-0482 / (910) 686-4281...
-
Page 2: Limited Warranty
This warranty is non-transferable. This limited warranty is subject to repair or replacement of defective components only. This warranty is void if the radio has been tampered with or misused. If your Stryker Radios needs repair any time during the (3) year warranty period please visit our website: www.StrykerRadios.com to obtain an RA number or call 910-221-1086 between... -
Page 3: Installation
Electrical Connections INSTALLATION The Stryker SR655 is designed to work on any 13.8 volt DC, negative 1. Contents ground electrical source. The condition of a vehicle’s electrical system Unpack and inspect your Stryker SR-655HPC for missing or can have a profound affect on the performance of the radio. A low damaged Components. - Page 4 Public Address Set your Stryker radio to your desired operating frequency or the To use the transceiver as a public address system, connect an external center of the range of frequencies you plan to use. Press the PTT 8 ohm speaker that is able to handle at least four watts to the PA jack on (Press-To-Talk) switch, and tap the antenna (making it shorter).
-
Page 5: Band Selector
This switch controls the "roger beep" circuitry. Simply put the Microphone Input: The Stryker SR655 accepts microphones with a roger beep is a tone that sounds when a radio operator un-keys their female 4 pin connector. For further wiring information please see the microphone. - Page 6 now be slightly stronger than the average received noise. Microphone Gain: Adjusts the microphone gain in the transmit and PA modes. This controls the gain to the extent that full talk power is available several inches away from the microphone. RF Gain: This control is used to reduce the gain of the RF (receive) amplifier under strong signal conditions.
- Page 7 OPERATION GUIDE For detailed descriptions of all functions please see page. Function Menu Button Monitor (Talkback) RF Power Output Control Band Selector Dimmer Switch Hi-Cut Receive Filter Roger Beep Switch Program Switch +10 KHz Switch S T R Y K E R Receive / Transmit 10 Meter Amateur Mobile Transceiver Channel Display...
-
Page 8: Alternate Microphones And Installation
ALTERNATE MICROPHONES AND INSTALLATION Before beginning the actual wiring, read carefully the circuit and wiring information provided with the microphone you select. Use the minimum For best results, the user should select a low-impedance dynamic heat required in soldering the connections. Keep the exposed wire type microphone or a transistorized microphone. - Page 9 The function menu allows you to customize many features as well as SCM: This menu is used to set the Scan mode. Options are as controls that your Stryker SR-655HP has to offer. To access the function follows: SQ: When SQ is selected, scan would stop when a valid signal menu press and hold the FUNC Button for approximately two seconds is detected.
-
Page 10: For Sales Information Please Contact
jack and the third option will display the model name during receive and the voltage during transmit. LOPT: The last option in the function menu is the the back light scan intervals, you can choose from 0.5 - 10 seconds. PRG Menu Navigation With the RB * PRG switch in the right position the LCD meter will display “1.