Related Manuals for Stryker SR-447HPC2
Summary of Contents for Stryker SR-447HPC2
- Page 1 For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com) 8312 Sidbury Rd.; Wilmington, NC 28411 - (800) 507-0482 / (910) 686-4281...
-
Page 2: Limited Warranty
LIMITED WARRANTY Stryker Amateur Radio warrants this product to be free of defects for a period of three (3) year from the original date of purchase.You must activate your warranty online at: http://strykerradios.com/registration-form Do not call to register your radio. -
Page 3: Installation
Electrical Connections INSTALLATION The Stryker SR447 is designed to work on any 13.8 volt DC, negative 1. Contents ground electrical source. The condition of a vehicle’s electrical system Unpack and inspect your Stryker SR-447HPC2 for missing can have a profound affect on the performance of the radio. A low or damaged Components. -
Page 4: External Speaker
Physical separation or 21 Set your Stryker radio to your desired operating frequency or the isolation of the microphoneand speaker is important when operating center of the range of frequencies you plan to use. Press the PTT the PA at high output levels. - Page 5 40 channels, with each channel being on a different display will show the current SWR such as 1.5. frequency. Microphone Input: The Stryker SR447 accepts microphones with Mon: The variable Mon control (talk back) is used to monitor your ...
- Page 6 Echo Volume: Varies the volume or number of echo repetitions. To increase the echo volume, rotate the control clockwise. Echo Delay: The Echo switch turn the echo on. A big advantage to this is you can turn it off and then back on with the switch without the need to adjust your volume &...
- Page 7 Quick Start Guide Detailed descriptions in user manual Band Selector A-H RF Power set 5 O’clock Talkback set to 11 O’clock Mode set to AM ANL & Noise Blanker set to NB+ Color and Dimmer set to middle position Volume Control Squelch set where ever you like Mic Gain wide open or turn down if needed RF Gain wide open or back off slightly...
-
Page 8: Alternate Microphones And Installation
ALTERNATE MICROPHONES AND INSTALLATION Before beginning the actual wiring, read carefully the circuit and wiring information provided with the microphone you select. Use the minimum For best results, the user should select a low-impedance dynamic heat required in soldering the connections. Keep the exposed wire type microphone or a transistorized microphone. -
Page 9: Programming Notice
Programming notice: The programming software for the SR-447HPC2 is available for down CTCSS and DCS code avaible for each single channel, when one load on our website www.strykerradios.com. A special USB cable is channel set a CTCSS or DCS code, you can hear on this channel required to program your radio.