Connect And Set Up; Connect The Main Unit; Network Setup Prompt; Charge Speakers - Philips Fidelio E6 User Manual

3 Connect and set
up
This section helps you connect this product to a
TV and other devices, and then set it up.
For information about the basic connections of
this product and accessories, see the quick start
guide.
Note
•
For identification and supply ratings, see the type plate
at the back or bottom of the product.
•
Before you make or change any connections, make sure
that all devices are disconnected from the power outlet.

Connect the main unit

With the supplied DIN cable, connect the left
base speaker to the right base speaker as main
unit. See the quick start guide for details.
Caution
•
When you plug the supplied DIN cable into the
connectors on the main unit, make sure that you plug
the DIN cable in the correct orientation to prevent
product damage.

Network setup prompt

When this product is turned on for the
first time, or network is not setup, you are
prompted to set up the network to stream
music from the online music apps.
» The network setup prompt is displayed
on the display panel of this product.
» The white LED on the right base
speaker blinks.
• To initialize network setup, see
"Chromecast built-in and Spotify Connect".
• To skip network setup, select other audio
input source.

Charge speakers

If the wireless surround speaker is undocked
from the main unit, its battery level is indicated
by the indicators on the wireless speaker.
Light up white: full battery or more than
•
30% capacity remaining
• Light up red: low battery level, less than
30% remaining
Blink red: near empty, less than 10%
•
remaining
1
Dock the left and right wireless speakers
onto the main unit (left and right base
speakers) to charge the speakers.
2
Turn on the main unit.
» During charging, the orange LED on
the wireless speaker lights up.
» When fully charged, the orange LED
on the wireless speaker turns off.
Note
•
It may take around 3 hours to fully charge the speakers.
EN 9