Connect Bluetooth Via Nfc; Auto Standby; Set Display Brightness; Apply Factory Settings - Philips Fidelio E6 User Manual

Note
•
The function of the remote control is not available to
this feature.

Connect Bluetooth via NFC

NFC (Near Field Communication) is a
technology that enables short-range wireless
communication between NFC-enabled devices,
such as mobile phones.
What you need
• A Bluetooth device with NFC function.
• For pairing, tap the NFC device on the
NFC tag of the right base speaker.
Note
•
NFC feature is only available to the main unit, not
available to the left and right surround speakers.
1
Enable NFC on the Bluetooth device (see
the device' s user manual for details).
2
Tap the NFC device on the NFC tag of
this product until you hear a beep sound
from this product.
• Make sure that this product is switched
on from standby, and is currently
disconnected from other Bluetooth
device.
» The BT on the display panel lights up,
and the NFC device is connected to
this product via Bluetooth.
» If the connection fails, the BT on the
display panel blinks.
3
Select and play audio files or music on
your NFC device.
• To break the connection, tap again the
NFC device with the NFC tag on this
product.
22 EN

Auto standby

Networked standby
When this product is connected to the
network, this product automatically switches to
networked standby after 15 minutes of inactivity.
Networked standby shortens the startup time
from standby, optimized for streaming music
from mobile apps.
ECO standby
When this product is not connected to the
network, this product automatically switches to
ECO standby after 15 minutes of inactivity. ECO
standby lengthens startup from standby, and less
power is consumed.
In the network status, you may also press and
hold
on the remote control to switch this
product to ECO standby.
Note
•
If this product is in ECO standby, the red LED on the
right base speaker lights up.
•
If this product is in networked standby, on the right
base speaker, the white LED lights up and the red LED
turns off.

Set display brightness

You can press DIM repeatedly to select a
different brightness level of the display panel on
this product.
If you select DIM 0, LED message is switched
off after 10 seconds of button inactivity.

Apply factory settings

In case of no response from this product or
network setup issue, you may reset this product
to the default settings programmed at the
factory.