Tools Required - Nautilus Trimline T523 Owner's Manual

⁄ ˝ Wrench •
9
16
LOCATE THE HARDWARE BAG SA2023 CONTAINING:
Part #
HH2102
MM2105
HH2168
HH2154
HH2095
HH2153
HH2001
MM0087
HH2217
FINAL ASSEMBLY IS COMPLETE AND MOTOR COVER IS INSTALLED.
STEP 1
Remove contents from box: (1) upright assembly, (2)
handrails, (1) hardware bag, (1) main base.
STEP 2
Remove motor cover to expose the motor (see Figure 1).
STEP 3
Install the upright assembly onto the upright brackets
on the treadmill frame (see Figure 2). Caution: Use care
not to damage the wires in the right upright.
STEP 4
Please note: the left upright is attached to the frame
differently then the right upright. If you stand on the
treadmill as if you were walking on it, your left hand
is on the left side of the treadmill, your right hand is on
the right side of the treadmill.
The left side is attached with clear nylon shoulder
washers. The right side is attached with metal star
washers.
A A S S S S E E M M B B L L Y Y
A A S S S S E E M M B B L L

TOOLS REQUIRED

⁄ ˝ Wrench • Phillips Screwdriver •
1
2
Description.
Button Head Bolt 5/16" X 1"
Nylon Shoulder Washer
Hex Head Bolt 5/16" X 1 1/2"
Black Flat Washer
3/8 Star Washer
Hex Head Bolt 5/16" X 5"
Hex Key Wrench
Hex Key Clip
Phillips Head screw
CAUTION: DO NOT PLUG IN POWER CORD UNTIL
I I N N S S T T R R U U C C
Y Y I I N N S S T T R R U U
FIGURE 1
FIGURE 3
Black Flatwasher
Shoulder washer
1" Button head
5
T T I I O O N N S S
C C T T I I O O N N S S
⁄ ˝ Hex Key (provided)
3
16
Qty.
8
4
2
12
4
2
1
1
7
*Make sure that shoulder washers are
seated into holes on upright tubes before
tightening.
Left Upright
FIGURE 2